How to use Motorcycle Spark Plugs

Using motorcycle spark plugs is a relatively simple process that can be completed with a few basic steps:
Identify the type of spark plug required for your motorcycle. Consult your owner's manual or a mechanic to determine the correct spark plug type and gap.
Make sure the motorcycle is turned off and the engine is cool before attempting to replace the spark plug.
Locate the spark plug on your motorcycle's engine. It is typically located near the top of the engine and can be identified by the spark plug wire connected to it.
Remove the spark plug wire from the spark plug. Be sure to grip the wire by the boot, not the wire itself, to avoid damaging it.
Use a spark plug socket and ratchet to remove the old spark plug. Turn the spark plug counterclockwise to loosen and remove it from the engine.
Inspect the old spark plug for signs of wear, such as discoloration or a worn electrode.
Install the new spark plug. Screw the new spark plug into the engine by hand, and then use a spark plug socket and ratchet to tighten it further. Be careful not to over-tighten the spark plug, as this can damage the threads in the engine.
Reattach the spark plug wire to the new spark plug. Push the boot firmly onto the new spark plug until it clicks into place.
Start the motorcycle and make sure the engine runs smoothly. If you notice any issues with the engine's performance, consult a mechanic to diagnose and repair the problem.
In summary, using motorcycle spark plugs requires identifying the correct spark plug type and gap, removing the old spark plug, inspecting it for wear, installing the new spark plug, and reattaching the spark plug wire. With the right tools and a little know-how, replacing motorcycle spark plugs is a simple and straightforward task.